







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Enterprise, NV: What It Costs and How Fast It Goes Up
A chain link fence in Enterprise, NV typically runs $3500 to $9000 for a standard residential lot, with most properties landing near the middle of that range. A typical install takes two to four working days from layout to final tension, and that includes the concrete cure time on your posts. The number moves mostly on footage, height, and what’s buried in the ground along the fence line. Call (844) 320-6757 and we’ll walk your property and put a written line-item quote in your hands.
How We Install a Chain Link Fence, Start to Finish

Every install follows the same five stages, and you’ll know what’s happening at each one before we pick up a tool.
Stage 1 – On-site layout and utility locate (day 1, 2 to 3 hours)
We walk the property line with you, mark the exact run, and confirm corners and any gate positions. You decide here: post spacing, gate swing direction, and whether the fence ties into an existing block wall or stands alone. Before anyone digs, we call for utility locates so nobody strikes irrigation, gas, or landscape power. In Enterprise, that locate step matters because tract lots in 89139 often have shallow irrigation lines running near the property edge.
Stage 2 – Ground prep and rock-breaking (day 1 to 2)
This is where southern Nevada jobs separate from the brochure. On desert-edge lots, crews hit caliche and hardpan just below grade, and that means rock-breaking before a post hole reaches depth. We dig and clean each hole to the right diameter and depth, then check plumb as we go. You don’t have to decide anything during this stage; we just keep you posted if the ground turns stubborn.
Stage 3 – Posts, concrete, and cure (day 2)
Line posts, terminal posts, and corner posts go in with concrete, and the concrete needs its cure time before any tension goes on the fabric. That cure window is why a chain link fence isn’t a one-day job here, even though the fabric goes up quickly once posts are set. Gate posts get the deepest footings because that’s where the swing stress lands.
Stage 4 – Rails, fabric, and gates (day 3 to 4)
Top rail, tension wire, and chain link fabric go up and get tensioned square. Gates hang with proper clearance so they swing without dragging. You decide at this point whether you want a walk gate, a drive gate, or both, and whether you’re adding privacy slats now or later.
Stage 5 – Walkthrough and cleanup (final day, about an hour)
We walk the whole run with you, test every gate, confirm tension, and haul off all debris and excess concrete. Any punch items get fixed on the spot. Your 730-Day Done Right Promise covers the workmanship from that walkthrough forward, and if something isn’t right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Chain link isn’t one product. The choices below are the ones that actually change how the fence looks and lasts.
- Gauge of fabric and wire. Standard residential fabric is a lighter gauge; heavier gauges resist bending and hold up better along a busy side yard or where kids and dogs lean on it. Heavier is worth it if the fence line will take real wear.
- Height. Common residential heights run from shorter boundary runs up to taller enclosures for pools or pets. Taller fence means more material and deeper footings on corners, which pushes the price up.
- Coating and finish. Galvanized is the budget-conscious choice and holds up well in dry desert air. Vinyl-coated chain link in black or green costs more but looks cleaner against stucco and blends with the surrounding desert palette better. Given the intense UV in Enterprise, coating also protects the wire underneath.
- Gates. Walk gates, drive gates, or double gates. Wider drive gates need heavier frames and better footings, and those are usually the largest single line item on the quote.
- Privacy slats. Inserted into the fabric for screening, and they’re a popular add-on where a side yard faces a neighbor. They don’t do much for sound, so don’t buy them expecting quiet.
- Tension wire and top rail. A tension wire along the bottom keeps the fabric from curling up over time. A full top rail gives a cleaner top line and better rigidity. Both are upgrades worth asking about.
What a Chain Link Fence Costs in Enterprise, NV

Residential chain link fence in Enterprise runs $3500 to $9000 as a working range. Here’s what separates the low end from the high end.
| Line item | Typical Enterprise range |
|---|---|
| Basic residential chain link install | $3500 – $5500 |
| Larger lot or taller fence | $5500 – $7500 |
| Full perimeter with drive gate and privacy slats | $7500 – $9000 |
| Rock-breaking for caliche/hardpan | Added to the base quote when hit |
What pushes a job toward the top of that range: more linear footage, taller fence, coated fabric instead of plain galvanized, heavy drive gates, privacy slats, and ground conditions that require rock-breaking. What keeps it lower: a smaller boundary run, standard height, plain galvanized finish, and clean soil. Corner and terminal posts always cost more than line posts because the footings are deeper.
A written estimate from us lists footage, post count and type, gauge, finish, gate specs, concrete, and any site prep for hard ground. It also lists what’s excluded, usually anything outside the fence line like old fence demo or landscape repair. Upfront pricing means the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise Homes Specifically Do to This Job
Enterprise is one of the fastest-built-out master-planned suburbs on Las Vegas’s south valley edge, and that shapes every chain link fence job here. The housing stock is overwhelmingly 1990s-through-2020s stucco-over-wood-frame homes on slab foundations on former Mojave scrub, so we’re working raw desert lots, not renovating old yards. That means we plan for caliche and hardpan just below the surface on the desert-edge lots in 89139, and rock-breaking is a real line item, not a surprise we spring on you later.
Two more things matter. First, HOA architectural review: many subdivisions in Enterprise require approval on fence finish and height before install, and we’ll tell you upfront whether your community falls into that group so you’re not stuck mid-project. Second, monsoon-season drainage: a fence set too close to a natural wash or a low spot in a graded lot can undermine over time, so we set posts and spacing to account for where water actually moves during a flash flood. Partners like Mighty Buildings and Tuff Shed come up on the larger site-planning side of these lots. If your fence is part of a full Fence Installation in Enterprise plan, we can look at how the chain link run ties into the rest of the perimeter. We cover all of Enterprise, including the neighborhoods off the south valley edge.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Enterprise

A typical residential chain link fence in Enterprise takes two to four working days, with the concrete cure time on posts being the main reason it isn’t a single-day job. Smaller runs with clean ground can finish closer to two days; larger lots with rock-breaking push toward four. Call (844) 320-6757 for a schedule based on your exact footage.
Permit requirements depend on height and location, and some HOA communities in Enterprise require architectural approval before install regardless. We pull the permits that are required and see them through inspection; you don’t have to chase paperwork. Call us and we’ll confirm what applies to your specific lot.
In most cases, yes. We call for utility locates before digging and route post holes to avoid irrigation lines and landscape features. Where a post has to land near a utility, we shift spacing and tell you before we dig. Homeowners often pair this with ADU Site Prep & Utilities in Enterprise when they’re fencing a lot that’s about to get reshaped anyway.
Chain link fence in Enterprise runs $3500 to $9000 for a residential install, and the high end comes from footage, height, coating, gates, and rock-breaking. We give a written line-item quote so you see exactly what you’re paying for. Call (844) 320-6757 – estimates are free.
Workmanship is covered by our 730-Day Done Right Promise, and if anything we installed isn’t right, we fix it. Gate hardware and moving parts get the most attention during your walkthrough. Homeowners often pair this with Door Installation in Enterprise while the exterior is already being touched. Our technicians have up to 12 years of experience, and you can see the full scope through our Fence Installation service.
Free Estimate for Chain Link Fence in Enterprise
Call (844) 320-6757 to schedule a free on-site estimate for your chain link fence in Enterprise. We’ll measure the run, check the ground, walk you through the options and a written line-item quote, and answer the HOA and permit questions before you commit. A live person answers around the clock. Technicians are background-checked and arrive in uniform.
Written by the team at Groundwork Construction Co.












