







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Enterprise, NV: What It Takes and What It Costs
Door installation in Enterprise, NV usually runs $450 to $1,900 per opening for a standard exterior or interior door, and most single-door jobs are finished in one day, with entry systems and multi-door packages stretching to two or three. The number moves with door material, frame condition, and whether your HOA architectural review has to sign off before we cut anything. Call (844) 320-6757 to schedule a free on-site estimate and we’ll put the range in writing before a single hinge is set.
The Door Installation Process, Stage by Stage

Most contractors treat a door swap as a two-hour errand. In Enterprise’s master-planned subdivisions it rarely is, because the frame, the stucco reveal, and the architectural rules all have to line up. Here’s how the job actually runs when we do it.
Stage 1: Measure and HOA check (day 0, about an hour)
We measure the rough opening, check the frame for plumb and square, and photograph the existing door so the replacement can match the community’s approved style and color. If your community has an architectural review board, we hand you the spec sheet you’ll submit. This is where a $450 interior door and a $1,900 entry system get sorted out, and where a wrong color choice gets caught before it becomes a violation.
Stage 2: Demo and frame prep (2 to 3 hours)
Old door and trim come out, and we inspect what’s behind them. In Enterprise’s stucco-over-frame houses we’re often looking at builder-grade framing that has shifted a little, and we shim and square it before the new unit goes in. Rotted sill plates get replaced here, not covered over.
Stage 3: Setting the door (2 to 3 hours)
The new unit gets set, shimmed, and checked for swing and latch alignment. Exterior doors get flashing tape and a proper sill pan, which matters more than most homeowners realize given the monsoon-season cloudbursts that roll through the south valley.
Stage 4: Insulation, seal, and trim (1 to 2 hours)
Low-expansion foam and caulk go in, interior and exterior trim go on, and the whole opening gets sealed against the desert heat gain. You decide the trim profile and finish at this stage if you haven’t already.
Stage 5: Hardware, adjustment, and walkthrough (about an hour)
Handles, locksets, deadbolts, and closers get installed and adjusted so the door latches clean. We walk the job with you and note anything that needs a return visit, which is rare. Total for a typical single door: one working day.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
What You’re Choosing Between: Door Options and Their Trade-offs
- Steel entry doors: $700 to $1,900 installed. Strong, secure, and holds paint well. Dents in high-traffic spots and can rust at the bottom edge if water pools. Best for front entries where security is the priority.
- Fiberglass entry doors: $900 to $2,200 installed. Won’t dent or rust, handles the UV and 100°F-plus summers here without warping, and can be finished to mimic wood. The finish costs more up front but the longevity is real.
- Solid wood doors: $800 to $2,000 installed. Beautiful and heavy. In Enterprise’s low humidity and hard sun, solid wood needs more maintenance and can move seasonally unless it’s well sealed.
- Hollow-core interior doors: $350 to $650 installed. Light and inexpensive. Fine for closets and low-traffic rooms, thinner sound barrier in hallways.
- Solid-core interior doors: $550 to $900 installed. Heavier, quieter, better for bedrooms and home offices. Slightly more framing and hardware cost.
- Sliding and patio door systems: $1,200 to $3,500+ installed. Great for opening a room to a patio, but the wider opening means more header and frame work, so the price climbs.
If you’re replacing doors as part of a full Windows & Doors in Enterprise project, we coordinate the door and window schedule so the trim and flashing line up rather than getting redone twice. For a broader look at materials and options, see our Windows & Doors service.
What Door Installation Costs in Enterprise, NV

Plan on $450 to $1,900 per door for a standard replacement, and $2,000 to $4,500+ for an entry system or a multi-door package. Here’s what pushes a job toward one end or the other:
- Door material and grade: a hollow-core interior door sits near the bottom, a fiberglass or solid wood entry at the top.
- Existing frame condition: square, solid frames are quick; shifted or rotted framing adds carpentry hours.
- Size and configuration: standard single doors are cheapest; double doors, sidelights, and transoms add material and labor.
- Hardware and finish: basic locksets versus keyed deadbolts, smart locks, and custom finishes.
- Permit and HOA scope: a like-for-like swap usually needs no permit, but a widened opening or new header can trigger a building permit and inspection.
A written estimate from us lists the door unit, hardware, labor, trim, disposal, and any permit fee line by line. What it won’t include unless we flag it: stucco repair around a new exterior opening, or a surprise sill replacement once the old door is out. We note both up front when we see them coming.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise Homes Specifically Do to This Job
Enterprise is one of the fastest-built-out master-planned suburbs on the south valley edge, which means the work here is production-grade tract and infill construction rather than old-home rehab. Nearly every house we open up is 1990s-to-2020s stucco-over-wood-frame with a tile roof and slab foundation. Builder-grade frames are common, and they don’t always stay square, so door installers here spend more time shimming and less time guessing about century-old lumber.
Two local realities hit this job directly. The first is your community’s architectural review. Many Enterprise HOAs approve specific door styles, colors (often earth tones that match the stucco), and hardware, and a replacement that doesn’t match can earn a violation notice. We build the ARB-approved spec into the order so the door you get is the door your community allows. The second is the desert itself: extreme heat and UV are hard on exterior finishes, and monsoon-season rain finds any gap in flashing. We work exterior doors accordingly, with proper sill pans and seals. If you’re adding a structure that needs doors matched to it, homeowners often pair this work with a Garage Conversion ADU in Enterprise. We work Enterprise and nearby south-valley communities, and we know the HOA landscape here.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Door Installation in Enterprise

A single door takes one working day, usually four to six hours including demo, setting, trim, and hardware. Multi-door packages or entry systems with sidelights run two to three days. Call (844) 320-6757 for a timeline based on your specific doors.
Usually not for a like-for-like replacement. You do need a building permit if the opening changes size, a new header is required, or the door is part of a structural addition. Your HOA architectural review is separate from the city permit and often the stricter of the two. Call (844) 320-6757 and we’ll tell you which applies to your address.
Yes, in most cases. A standard replacement fits the existing opening with no structural or plumbing changes. It’s only when you widen a doorway, add a new opening, or convert a closet that framing and possibly electrical come into play. Call (844) 320-6757 to talk through your plan.
Expect $450 to $1,900 per door for a standard replacement, and $2,000 to $4,500+ for entry systems and multi-door jobs. Material, frame condition, size, and hardware are the big variables. Call (844) 320-6757 for an exact quote; estimates are free.
Workmanship is covered by our 730-Day Done Right Promise, and manufacturer warranties carry through on the door units themselves. If something isn’t right within the promise window, we come back and make it right. Call (844) 320-6757 with any coverage question before you book.
Get a Free On-Site Door Installation Estimate in Enterprise
Every door job in Enterprise starts with a free on-site estimate. We measure the opening, check the frame and the HOA requirements, and hand you a line-item quote with the price locked in writing. You’ll reach a live person 24/7 at (844) 320-6757, and our technicians have up to 12 years of experience on the tools. New doors are one piece of the puzzle, and homeowners often pair this with Cabinets & Countertops in Enterprise when a whole room is getting refreshed. Call (844) 320-6757 today.
Written by the team at Groundwork Construction Co. of Henderson.












